13 Jul Step 3: Now let’s configure up both the WAN and LAN interfaces on the router like so: MICHAEL#conf t. Enter configuration commands. 21 Aug Setup Cisco with outside access (internet access); Setup Cisco as a For this example, Ethernet 0/0 will be used as the outside Now let’s configure up both the WAN and LAN interfaces on the router like so. For Cisco Router, you can follow these steps following. 1. Enter configuration commands, one per line. Router(config)#hostname MICHAEL

Author: Nezshura Mazutaur
Country: Tanzania
Language: English (Spanish)
Genre: Video
Published (Last): 5 September 2014
Pages: 468
PDF File Size: 10.63 Mb
ePub File Size: 7.56 Mb
ISBN: 120-3-51133-587-9
Downloads: 61188
Price: Free* [*Free Regsitration Required]
Uploader: Majas

Wed Mar 09, System Bootstrap, Version Here’s a link for you on the general config that you want to do: They can only be used as routed ports.

*How To* Configure and get started with Cisco |

Sun Mar 06, 2: It is different than configuring a layer 3 switch router interfaces which show up as int vlan x If you need both network interfaces you will need to use the dot1q encap to a switch that speaks dot1q and have subinterfaces for each vlan interface.

Look for royter guide for the IOS version you cisco 1841 router configuration guide running.


So I believe my problem confiburation most likely that I need another FastEthernet port on a modular card, cisco 1841 router configuration guide of trying to use one of the 2 interfaces built into the router already, if I understand correctly. Sat Mar 05, 6: Thanks for the help. Depending on what you are trying to do. Okay, So a router needs an interface on a maintenance vlan and it needs interfaces on the regular network? Model, IOS and interfaces would be nice at least.

Cisco VLANs – Ars Technica OpenForum

Vlan interfaces on a router like that when supported appear as sub-interfaces to the physical interface. I’ll try doing some research on Cisco’s site on dot1q stuff.

Compiled Wed Oct Originally posted by erratick: These three sites have or series routers and Catalyst switches. Mon Mar 07, I can’t seem to find the equivalent of this guide: What Monkyman said is correct, from what I have read.

Nope, unless you are trying to use that thing as a switch. They’re being plugged into Catalyst switches whose exact model number I can’t remember right now.

Cisco 1841 router configuration guide the end, I’ll have a North, South, and Central site, all with devices plugged into certain ports of the Catalyst s and routing between each other with the Cisco routers.

The onboard ports however cannot be made cisco 1841 router configuration guide switchports and are only supported as routed ports, which is where I think the OP is running into a problem.


Am I way off base somehow? Mon Mar 07, 1: Jul 13, Posts: What type of switch are you plugging the routers into? Sep 1, Posts: Basically the switch that the router is connecting to will need to guids If I enter interface configuration mode, “encapsulation” is not a recognized command, so apparently things changed between and series cisco 1841 router configuration guide.

Posting Guidelines Contact Moderators. To give a better overall picture of what I’m trying to do, we have sixteen sites connected through frame relay, with a hub site and fifteen cisco 1841 router configuration guide connected to it.

The etherswitch ports can be assigned a vlan just as a switch in addition the SVI can be used to route that vlan i. Sun Mar 06, Sat Mar 05, 3: Originally posted by monkyman: Sun Mar 06, 3: SpacemanSpiff Ars Centurion Tribus: